It is located in the back of the car on the passengerside under neath the plastic. whhen you remove the plastic there will be a sticker there with numbers it is the one with 5 diigits.
I have a 1998 and the code is in the back where your jack and accessories are.
the keyless entry code is inside the cover in the back where the rear windshield washer container is
there is a "wallet card" which has the code on it, if you do not have this card you will need to bring the car into a Mercury dealer and they will "plug it in" and retrieve the factory preset code.
My code was located in the compartment with my jack. It is on the side of the white computer box. Hope this helps.
To locate the keyless entry code for a 2007 Mercury Mountaineer, check inside the driver's side door. You can often find a label with the code on the inside of the door frame or on a card in the owner's manual. If you cannot find it there, you may need to contact a dealership or a locksmith for assistance, as they can retrieve the code using the vehicle identification number (VIN).
On a 2009 Mercury Mountaineer, the keyless entry code can typically be found on a label attached to the driver's side door. Look for a small tag or sticker, which may be located near the door latch or on the driver’s side B-pillar. If the code is not visible, you may need to consult the owner’s manual or contact a dealership for assistance.
the rear passenger door (back right), open the door.. where the seatbelt is stored at, lift that panel & the keyless code is a 5 digit code on a white sticker on the metal frame under that panel.
Keyless entry codes for most makes and models can be obtained from a dealership with the VIN number and identification. If the code has been changed by a third party then the dealership will not be able to retrieve it.?æ
sticker in the glove comparment or you can program your own with the manual or go to the dealer,they might charge for it.
what does a insufficient coolant temperature for closed loop fuel control mean and what can i do to fixs it on a mercury mountaineer 1997 engine is a 5.0
Trouble code P0401 means:Exhaust gas recirculation flow insufficient detected
Open your drivers door and look for an information sticker , the trans code should be shown