Go to your Chevy dealer parts department; they can print a copy for you.
replacing serpentine belt on 2000 chevy prizm need help
Buy a Haynes or Chilton repair manual from a parts store.
The routing diagram for the serpentine belt on a 1998 Chevy Prizm with a 1.8L engine typically shows the belt looping around several pulleys, including the crankshaft pulley, alternator, power steering pump, and the idler pulley. The belt should be routed in a way that ensures proper tension and alignment with the pulleys. For accurate installation, refer to a detailed diagram usually found in the vehicle's service manual or on a label under the hood. Make sure the belt is properly tensioned after installation to avoid slippage.
A picture diagram of the drive belt routing is suppose to be on either the underside of the hood, close to the latch assemble or on the radiator support panel. also it as the same routing as a Toyota Corolla 1.6 liter 1987-1992.
The Prizm has a timing CHAIN, not belt. The timing chain does not get replaced on a scheduled interval. It should never need to be replaced. The serpentine belt, however, does need to be replaced. Inspect the belt for cracks and glazing, and replace. It is not a difficult DIY job. It is easiest to do it from under the car, after removing the splash pan.
Type your answer here... where is the coolant sensor ona 2001 chevy prizm
belt diagram for a 1996 Geo Prizm
where is the vacuum diagram located on 1995 geo prizm
autozone.com-- look for the water pump that you need for the Chevy, then loook at the job diagram, this works for any part on any car, truck, etc.
This might be helpfful. How do you Change a fan belt on 94 prizm?
It is squealing because it is loose or worn out. Tighten it and if that does not help, replace it. If it is a serpentine belt, just replace it and check to make sure the idler tensioner is working properly.
no, prizm is a re bage of Toyota collora