in the Chevy Malibu forum
on a 2000 Malibu it is on passengers side under alternater 3.1 v6, follow hose from ac you will find it.
location of ecm on 1998 Chevrolet Malibu
Were is locate the snock sensor of chevi malibu 99
To recharge the air conditioner in a 2002 Chevy Malibu, first locate the low-pressure service port, which is usually near the accumulator or dryer. Attach a refrigerant can with a gauge to this port, following the instructions on the can for proper use. Start the engine and turn the AC to its maximum setting; then, slowly release the refrigerant into the system while monitoring the pressure gauge. Once the recommended pressure is reached, disconnect the can and replace the port cap.
follow top radiator to end of hose, the thermostat is in the housing at end...
To recharge the air conditioning system on a 2001 Chevrolet Malibu, first, locate the low-pressure service port, typically found on the larger diameter line. Purchase an R-134a refrigerant recharge kit, which includes a gauge and hose. Attach the hose to the low-pressure port, start the engine, and turn on the AC to the maximum setting. Follow the instructions on the refrigerant can to add the refrigerant until the correct pressure is reached, as indicated by the gauge.
if u look from the driver side it is directly behind the engine it has a blue cap on it almost right behind the belt. so the easiest way to get to it will be fro the passenger side but the way to see it and locate it is from the drivers side
This vehicle has electronic steering assist and does not require power steering fluid. I had the same question so I looked it up in my manual and found this out.
Locate the drain plug on the oil pan, remove it, and let the old oil drain. Then locate and remove the oil filter, wipe some oil on the rubber seal of the new filter, then replace the drain plug.?æ
To jack up a 2000 Chevrolet Lumina safely locate all the jack points found on the bottom of the chassis. These jack points will be reinforced to handle the extra weight and pressure.
Your oil pressure sending unit should be located above the oil filter, on the housing the oil filter screws up to.
The best thing to do is go to bgfindeashop.com and locate a repair shop that has the BG chemicals. They will install a cleaner then back flush the system including the heater . Then they add a fluid conditioner.