0
This is something you want to be sure about. I would check with the manufacterer. If you fasten the steel improperly, it could void the warrenty on it. Some contractors argue over which way is better: screw or nail on top of the rib, or screw or nail along side the rib. either way is sufficient. I prefer to screw on the top of the rib because it wont be in the trough that the water runs down, thus less water exposure to the rubber gasket on the screw. hope this helps.
Shane (vmax33)
What else can I help you with?
How far apart should screws be placed in a metal roof?
how far apart should screws be placed ina metal roof
How do you roof a valley on a metal roof?
Valley trim is usually installed onto the roof preceding the actual roofing panels. If you are using standard panels with W-Valley trim (or similiar) the Valley trim is screwed directly into the lathe using "Quick-Drill" (metal-to-wood) screws.
What type of screws are recommended for securing metal doors?
The type of screws recommended for securing metal doors are self-tapping screws or machine screws. These screws are designed to securely fasten metal doors in place.
How can I effectively screw down a metal roof?
To effectively screw down a metal roof, start by ensuring the roof panels are properly aligned and securely fastened to the roof structure. Use the appropriate screws and a power drill to drive the screws into the designated spots on the roof panels, making sure they are tightened securely but not over-tightened to avoid damaging the panels. Work systematically from one end of the roof to the other, following the manufacturer's guidelines for spacing and placement of screws. Regularly check the tightness of the screws and make any necessary adjustments to ensure a secure and weatherproof installation.
Are the roof rails on an 01 Jeep Cherokee Sport held on by sheet metal screws?
their are nutcerts in your roof. which use Allen head type srews. the Allen screws go through your roof rail and screw in. be sure not to over torque them. it can stripp your nutcerts.
How can I make a roof ladder hook?
To make a roof ladder hook, you will need a sturdy metal hook, a piece of metal tubing, and some screws. Attach the hook to one end of the tubing and secure it with screws. Then, attach the other end of the tubing to your ladder. This will allow you to safely hook the ladder onto the roof while working.
Should you place stripping lumber over shingles Before placing metal roof?
No
What are the best types of screws to use for securing HVAC equipment?
The best types of screws to use for securing HVAC equipment are self-tapping screws or sheet metal screws. These screws have sharp points that can easily penetrate metal surfaces, making them ideal for securing HVAC equipment securely in place.
What size roof screws do you use?
2" inch
How do you remove Roof rails and trim from a Volvo V70?
To remove the roof rails and trim from a Volvo V70, start by using a trim removal tool to carefully pry off any plastic covers or caps that conceal the mounting screws. Next, unscrew the bolts holding the roof rails in place, typically found at the base of the rails. Once the screws are removed, gently lift the roof rails off the vehicle. Finally, for the trim, locate any screws or clips securing it and remove them before pulling the trim away from the roof.
Where are metal studs used?
metal screws
How many screws do you put in a metal roof?
The method of installing screws in a metal roof will vary depending on the type of metal roofing being installed, and the manufacturer who is backing the warranty on said panel. A list of installation guides for popular panels is found here as examples: http://www.bestbuymetals.com/how-to-install-metal-roofing.html Check with the manufacturer of your particular panel type.
