answersLogoWhite

0

between the hood and the windshield

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the control module located in a 2000 Chrysler lhs?

Engine, transmission, and abs are under the hood. Body, HVAC, airbag are in or behind the dash.


Is there a valet switch on a 2000 Chrysler LHS?

NoNo


Where is the battery located in a 2001 Chrysler lhs?

The battery is located under the hood on the passenger side in a 2001 Chrysler LHS. The battery is held in place by two 9mm screws.


Location oil pan 2000 lhs Chrysler?

On the bottom.


Where is oil pan location 2000 lhs Chrysler?

the bottom


Where is the fuel filter on the 2000 Chrysler LHS located?

In the fuel tank


Were exactly is the fuel pump on a 2000 lhs 3.5 liter car?

were exactly is the fuel pump on a 2000 chrysler lhs 3.5 liter car?


Is a Chrysler lhs 2000 3.5 liter an interference type motor?

Yes.


When was Chrysler LHS created?

Chrysler LHS was created in 1994.


Where is the fuel pump relay on a 1997 Chrysler LHS?

It is in the under hood fuse box. The lid is labeled.


How to change a battery on a Chrysler 2000 LHS?

To change the battery on a 2000 Chrysler LHS, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the battery; disconnect the negative terminal (black) first, followed by the positive terminal (red). Remove any securing brackets or clamps, then lift out the old battery and replace it with the new one. Reconnect the terminals, positive first and then negative, and ensure everything is secured before closing the hood.


How do you replace headlight on a 2000 lhs Chrysler?

To replace the headlight on a 2000 Chrysler LHS, first, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector by pressing the tab and pulling it off. Remove the retaining clips or screws securing the headlight assembly and gently pull it out. Install the new headlight by reversing the process, ensuring the connector is securely attached and the assembly is properly seated.