0
What else can I help you with?
How do coil wires install on 1967 Chevelle?
To install coil wires on a 1967 Chevelle, first ensure the ignition is off and the battery is disconnected for safety. Identify the coil terminal for the positive (usually marked with a +) and negative (marked with a -) connections. Connect the positive wire from the ignition switch to the positive terminal of the coil, and then connect the negative wire from the coil to the distributor. Finally, double-check all connections for security before reconnecting the battery and starting the vehicle.
How do you wire a tachometer to a 1974 Valiant?
you can wireit directly to the coil... check for the positive and negative wires or there is also a place in your distributor.......
What does positive of the coil mean?
The COIL HAS A POSITIVE AND A NEGATIVE TERMINAL. If you look at the top of the coil, it is generally marked + and - on the top.
Converting from points to electronic ignition are the wires connected pos to pos or pos to neg on 305 Chevy on coil?
remove resistor from loop positive to positive terminal neg to neg
Where to hook up the wires for a tach on a 1985 Chevrolet s10 blazer?
You should hook up the wires for a tach on a 1985 Chevrolet s10 blazer to the negative side of the coil. You should be sure to identify the positive and negative sides of the coil.Ê
Which wires go to where on the coil with points What goes to positive and what goes to negative Its on a 67 Glastron boat with a 60hp Mercruiser..?
Not sure about your specific model, but the negative side goes to ground, the positive side goes to the wire that is hot when your key is turned to the on position. You can tell the positive side of the coil as it will have continuity between both the primary and secondary sides of the circuit. (The negative terminal being the primary and the coil wire going to the distibutor being the secondary.)
How do you put spark plug wires in the right place on the coil pack on a 1995 Chevy Cavalier?
how do you put spark wires in the right place on the coil pack on a 1995 Chevy cavalier2.2 frank
How do you connect a tachometer to a gmc 4-cylinder with coil packs?
There are two ways that you can do this: 1.From the ECU Cable, that's on the GMC, looking from the bottom of the wire harness clip, the 4th wire from the left bottom series of wires for negative, and the positive on the 2nd wire from the right hand side top series of wires. 2. attach wires from the tach from the negative side of the main branch of the coil pack positive wire, and negative to the negative wire. Then after that's done it should work, depending if you need a power supply from battery or turn-key acc on wire.
Why is your 1997 Chevy s10 arching up the tube on the coil back to the metal on the coil?
To much resistance in the spark plug wires, replace the spark plug wires.
How do you replace a 1970 Chevy ignition coil?
take the wires off the + and - side of the coil, pull the coil wire out of the coil, unbolt the coil from the manifold, to install just reverse directions.
What wires go on Ignition coil hookup on 1967 Chevy Nova?
here is a diagram
How do you change a pick up coil on a 1985 Chevy?
if the coil is on the distributor cap,remove cover then disconnect wires from the coil and remove coil. if coil is on engine then loosen the bolt and remove from coil mount
