answersLogoWhite

0

It doesn't have a speedometer cable. The speed signal comes from the output speed sensor.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the odometer cable in a 1996 Chrysler town and country?

A 1996 Chrysler Town and Country does not have a speedometer or odometer cable. That signal comes from the transmission output speed sensor.


How do you replace speedometer cable for a Chrysler town and country?

Town and country vans have never had speedometer cables. The speedometer gets it's signal from the transmission computer.


Where is the speedometer cable in a 2006 Chrysler 300?

There is no speedometer cable. The speed signal comes from transmission and abs speed sensors. Chrysler last used a cable in the 1980's.


How do you reset Chrysler transmission codes?

with a scan tool or disconnect the battery count to ten then replace cable


What does it mean when a 1995 Chrysler New Yorker wont go into gear?

Shift cable has unhooked, fluid too low, transmission failed.Shift cable has unhooked, fluid too low, transmission failed.


Why will a 1989 Chrysler New Yorker not shift into reverse?

Shift cable adjustment, low fluid, internal transmission failure.


Where is the temperature control cable on a 2001 Chrysler Town and Country?

There is no temperature cable. The hvac outlet temperature is controlled with electric motors on airflow doors.


Where is the speedometer cable on a 1993 chrysler new yorker?

It does not have a speedometer cable. The system is all electronic. There is a sensor at the passenger axle output housing of the transmission.It does not have a speedometer cable. The system is all electronic. There is a sensor at the passenger axle output housing of the transmission.


How do you replace the gear shift cable on 2001 Chrysler Concorde?

To replace the gear shift cable on a 2001 Chrysler Concorde, start by disconnecting the negative battery terminal for safety. Then, remove the center console to access the cable, detaching any clips or fasteners holding it in place. Next, disconnect the cable from the transmission and the shifter, and replace it with the new cable by reversing the removal steps. Finally, reassemble the console and reconnect the battery.


How can you put an automatic Chrysler PT Cruiser in neutral without the key?

You would need to take the shift cable off at the transmission and move the lever manually.


Is the transmission on a 90-91 Integra cable or hydro?

its a cable transmission


Where is the shifter cable on a 1991 Chrysler LeBaron?

On a 1991 Chrysler LeBaron, the shifter cable is located underneath the vehicle, connecting the transmission to the gear shift lever in the cabin. It's typically routed along the underside of the car, near the transmission, and may be accessible from beneath the vehicle or through the console area inside. Always ensure the vehicle is properly supported before attempting any inspection or repairs.