in the 3.0l models it is located right on top of the transmission. It makes a difference in sensors if you have the analog or digital cluster on the dash.
The vehicle speed sensor is on the transmission. The ABS speed sensor is on the differential.
i think that it might work
"Where is the crankshaft position sensor on a 96 ford probe SE?"
On the manual transaxle, the VSS (Vehicle Speed Sensor) is on the top rear of the transaxle, pretty much directly below the MAF (Mass Airflow) sensor.
Code 55= "No input signal from vehicle speed pulse generator"
Pulse signals from what? speed sensor abs wheel sensor fuel pump pressure sensor crankshaft sensor camshaft sensor knock sensor
The nosiey engine in ford 1990 how can we overcome it?
What is your question?
To locate and replace the speed sensor in a 1989 Ford Probe LX with a digital dash, first, ensure the vehicle is safely lifted and secured. The speed sensor is typically located on the transmission, near the output shaft. Disconnect the electrical connector and remove the retaining bolt to take out the old sensor. Install the new sensor, reattach the connector, and ensure everything is secured before lowering the vehicle.
While the 1993 Mazda MX-6 and the 1994 Ford Probe share similar platforms and components due to their shared development by Mazda and Ford, compatibility of the speed sensor can vary. It's recommended to check specific part numbers and compatibility guides, as there can be differences in electrical connections or design. If the part numbers match, it's likely that the speed sensor will work; otherwise, it's best to consult with a mechanic or parts specialist.
no but if you can find an 88 to 92 tranny it will work fine
Speed sensor on a 2001 ford expedition