Look at the bottom or rear of radiator
The drain plug is at the bottom of the radiator on the driver's side. There is a valve located on the engine side of the radiator.
There isn't one. To flush my radiator in my 2000 I had to take off the lower rad hose.
Where is the radiator cap located on a 2000 Oldsmobile Alero?
You can find it at bottom of the radiator, also there is a special drain plug in the engine body.
Follow the upper radiator hose to the engine. It should be located in a housing near where the hose connects to the engine.
To flush the radiator on a 2000 Pontiac Montana, start by ensuring the engine is cool and then locate the radiator drain valve at the bottom of the radiator. Open the drain valve and allow the old coolant to drain into a suitable container. Next, close the drain valve, fill the radiator with a radiator flush solution and water, run the engine for about 10-15 minutes with the heater on, then drain again. Finally, refill the radiator with fresh coolant and check for any leaks.
bottom of radiator on right side facing engine
Bake a radiator?
On a 2000 Cadillac Escalade, the radiator drain is typically located at the bottom of the radiator on the passenger side. It is often a plastic or metal petcock valve that can be turned to release coolant. Make sure to have a container ready to catch the coolant when you open the drain. Always ensure the engine is cool before attempting to drain the radiator.
There is a screw that you loosen on the driver side on the inside (towards the engine) that you turn to drain the radiator. WE didn't think there was one but then we found it.
Drain valve is on bottom of radiator on passenger side. Valve at controls flow is directly above facing the engine. quite difficult to get to.
it is inside the thermostat housing, which is where the upper radiator hose connects to the engine. the metal that the hose clamps to is the housing.
The drain plug on a 2000 Dodge Durango radiator is typically located at the bottom of the radiator. It may be a small plastic or metal valve on the driver's side or the passenger's side of the radiator. To drain the coolant, you'll need to unscrew or pull the drain plug, so be sure to have a container ready to catch the coolant. Always make sure the engine is cool before attempting to drain the radiator.