0
What else can I help you with?
96 probe gt with klze has codes p0120 and p0325 what are they?
P0120 Throttle Position Sensor P0325 Knock Sensor This is codes that are telling you that the TPS sensor and the Knock sensors are faulty.Replace them.
Where is the 93 ford probe gt knock sensor?
On the Ford Probe 93-97 GT's the knock sensor is located underneath the intake manifold. More specifically it is threaded into a fitting on the deck of the engine block in between the heads in the Valley. Shouldn't be too bad if your an experienced mechanic or a mechanically inclined individual. Hope this helps ya out, and good luck.
How do you install brake pads on a 96 Ford Probe gt?
dont try this at home
Where is your cam sensor on your Ford Probe gt?
the camshaft sensor is located in the distributor. you need to purchase the entire distibutor to replace the sensor.
Location of knock sensor on 2002 Pontiac grand prix?
location knock sensor 2002 pontiac grand prix gt 3.8 engine
When ford probe 95 engine 2.5 GT is hot -is not working?
Temperature coolant sensor...
1996 Probe GT code reader says o2 Sensor Bank 2 Sensor 1 is out is this front or rear sensor?
(front) sensor 2 is after the cat
Where is the OBD II connector on a 96 Ford Probe gt?
Next to the "Pop the hood" lever inside the car.
Vacuum hose routing diagram for aford probe gt 94-96?
For a 1994-1996 Ford Probe GT, the vacuum hose routing diagram typically includes connections for the intake manifold, brake booster, and various sensors like the MAP sensor. The vacuum lines generally run from the intake manifold to the brake booster and other components, ensuring proper engine performance and emissions control. For precise routing, it is advisable to consult a repair manual or a service guide specific to the Probe GT model.
What is the probe size?
Probe,probe se 2.0 / probe gt 2.5
Where is the oil pressure sending unit on a 1993 ford probe GT 2.5 engine?
I haven't looked on my '96 GT, and the manual just says "somewhere near the oil filter".
Where is the knock sensor on a 1997 subaru legacy gt 2.2 liter?
It is threaded into the block, under the intake manifold.
