They are in the exhaust flow
did u ever figure it out?
The EGR valve, on your 1995 Oldsmobile 2.3 liter engine, is located on the side of the air filter housing. The valve should be labeled as such.
changing the crankshaft sensor
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
Can you show me a diagram of the upstream oxygen sensor on a 3.5l liter Oldsmobile Intrigue engine?
The throttle positioning sensor is located in the throttle body.
On a 1997 Oldsmobile Achieva with a 2.4-liter engine, the ignition coils are located on the engine's top, mounted to the ignition coil module. This module is situated near the front of the engine, typically near the intake manifold. To access the coils, you may need to remove any engine covers or components obstructing the area.
What are the torque specificatons for a 1996 v6 3.1 head on an oldsmobile achieva
On a 2004 Oldsmobile Alero with a 2.2-liter engine, the upstream O2 sensor is located in the exhaust manifold, before the catalytic converter. It is typically found on the exhaust pipe just after the engine's exhaust ports. This sensor monitors the oxygen levels in the exhaust gases to help optimize fuel efficiency and emissions.
The map sensor for a Chevy 5.3 liter engine is on the top of the intake. It is at the back of the engine.
that would be 5.7 Liter
The torque specification for the rocker arm bolts on a 1997 Oldsmobile Achieva with a 3.1-liter engine is typically around 22 foot-pounds (30 Nm). It's important to follow a specific tightening sequence to ensure even pressure and prevent damage. Always refer to the vehicle's service manual for the most accurate specifications and procedures.