0
What else can I help you with?
Where is the oil sending unit located on 1981 Pontiac Bonneville 265 engine?
The oil sending unit is located on the 1981 Pontiac Bonneville 265 engine is located on the Starter Disable Kit.
Where is the oil sending unit found on a 99 Pontiac sunfire?
The 1999 Pontiac sun fire oil sending unit is located in the bottom of the engine. You will need to remove the oil pan in order to view the oil sending unit.
Where is the temperature sending unit sensor on a Pontiac 2006 g6?
Where is the temperature sending unit located on a 2006 Pontiac g6
Where is the oil sending unit on a 1995 Pontiac Trans Am?
Oil pressure sending unit Where is it at on the engine
Where is the gauge sending unit located on a 1994 Pontiac Transport 3.8L engine?
When my 1994 Pontiac Transport is in park and idling the the speedometer runs erratically? Why?
Where is the oil pressure sending unit located on a 1986 Pontiac fiero 2.8 liter engine?
Left of the bottom left corner of the battery.
Where is the oil sending unit located on the 2001 Chevy 4.3 vortec engine?
Where is the oil sending unit located on the 2001 Chevy 43. vortec engine?
Where is the temperature sending unit on 1996 F150?
Coolant temperature sending unit is located on the front of the engine. The cooling temperature sending unit will be on the right hand side of the engine.
Where is the temperature sending unit located on a 2.5 engine?
The temperature sending unit on a 2.5 engine is on the passenger side of the engine. It is between the exhaust ports.
Where is Engine oil sending unit Dodge Intrepid 2.7L?
The engine oil sending unit on your Dodge 2.7 liter engine is located in the bottom of the engine. The oil sending unit can be accessed by removing the oil pan.
Where is the oil pressure sending unit located on a 2003 pontiac bonneville?
It's located by the oil filter
Why would the temperature gauge not be moving on a Pontiac Montana?
Try to locate the temperature sending unit on the engine and make sure its not a loose wire to the sending unit,if the wire is in place then the sending unit is shot.
