answersLogoWhite

0

Drain the radiator into a container. Remove the upper radiator hose at the engine end. remove the 2 bolts in the thermostat housing and remove the housing. Remove the thermostat and clean both surfaces. Install the new thermostat and seal and then install the housing and bolts. Reinstall the upper radiator hose and refill the radiator.jd

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace the thermostat located on a 1994 Chevy Impala?

The thermostat is located in the thermostat housing at the engine end of the top radiator hose.


Instructions for replacing a heater core on a 1996 Chevrolet Impala SS?

how to replace a heater core on 1994 impala ss


Where is the thermostat on a 1994 Chevy Beretta 3.1 z26 and how do you replace it?

The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.


How do you replace thermostat on Honda Civic?

how do you replace thermostat on 1994 Honda civic dx


Where is the PCV valve on your 1994 Chevrolet Impala?

It is located in the right valve cover.


How do you replace the thermostat located on a 1994 Pontiac Bonneville?

Where is the thermostat


How do you fix the speedometer on a 1994 Chevrolet Impala SS?

To fix the inoperative speedometer you will need to replace the speed sensor. It is located on the side of transmission and has 2 wires coming out of it.


How do you replace the thermostat located on a 1994 Chevy Cavalier?

where do i find the thermostat for 99 cavalier


How do you replace 1994 volkswagen golf water pump?

How to install thermostat in a 1994 volkswagen golf?


How do you replace the thermostat on a 1994 Mercury Cougar?

What is the motor size? Run1


How do you install a fuel pump on a 1994 Chevrolet Impala SS?

You will have to remove the gas tank and install a fuel pump module.


What makes the belt noisy on 1994-1996 Chevrolet Impala SS?

The tensioner is usually the problem and/or not using a quality belt.