Pull right front tire. Remove plastic from wheel well. Sensor is on block beneath the water pump and above the Harmonic Balancer.crank shaft sensor is under front of motor behind crankshaft pulley (Harmonic Balancer). some you have to take crank pulley off to access. wires unplug under car close to front. if you have help, someone can test wires with meter while you try to start engine. this will tell you i they are bad.
You have to dismantle the entire engine,,,NO YOU DO NOT ITS JUST YOU HAVE TO DRAIN THE OIL TAKE THE OIL PAN OFF AND GET THAT DANG SENSOR TAKEN OUT THEN REPLACE IT!!
where is the computer box on the 1995 ninety eight oldsmobile?
All throttle Position Sensors are on the throttle body
One at a time.
The MAP sensor is located on the throttle body. There are two screws that secure it in place.
looking for the car code for a ninety eight 1989 oldsmobile
115
If your car is that old and you aren't trying to restore it for a collection you probably should get a new car
in the filler tube on engine
It is located by the harmonic balancer right next to it to remove it you must take the hb off to properly take it off...
disconnect the hoses and drop the gas tank to access the pump mounting on top of the tank.
p205 70 r15