The blower resistor on a 2008 Ford Escape is typically located in the HVAC housing, which is situated under the dashboard on the passenger side. To access it, you may need to remove the glove compartment and some paneling. The blower resistor is usually mounted to the HVAC assembly and connected by a wiring harness. If you're experiencing issues with the blower motor speeds, checking the resistor is a good first step.
The blower resistor has failed.The blower resistor has failed.
They are generally found close to the blower motor.
to the right of the gas peddal
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
Behind the glove box.
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.
The blower motor fan cools the resistor so the resistor is usually located close to the blower.
The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
Your truck has both. the resistor is between the switch & blower.thje resistor controls the blower speed
resistor for fan blower is in back of glove box, beside the blower itself.
Heater blower resistor is what controls the low medium high speeds...