0
Chilton section 9-3 front wheel drive Chrysler 4 cyl cars, figure 5; the brake light switch is mounted to the brake pedal bracket assembly, under the instrument panel. The stop lamp switch is attached to the mounting bracket.
1. Disconnect the negative battery cable,
2. unplug the two brake switch wiring harness connectors,
3. remove the wiring harnessfor the switch lamp from the clip on the brake pedal assembly. Remove the nut and washer from the switch and bracket assembly stud and remove the switch and bracket assembly.
Note: you may have to remove the steering column in order to access the switch bracket.
What else can I help you with?
Where is the back up light switch on a 1986 LeBaron?
It's part of the neutral safety switch on the front of the transmission.
Why does your brake light stay on for a 1986 F-150?
STICKING BRAKE LIGHT SWITCH AT THE TOP OF THE BRAKE BEDAL
Brake light on 1986 Chevy s10?
The brake light switch located above the brake pedal is broken or out of adjustment.
How do I replace brake light switch 1986 corvette?
Brake light switch is located on the brake pedal arm. Unbolt & bolt in new one. Wiring will unplug & plug back in to new switch.
Brake light won't work on 1986 Chevy caprice classic?
Check the brake light switch on the brake pedal. Might have to replace it.
What causes the brake light to stay on in your 1986 Dodge D150?
possibly a bad brake switch located on the brake pedal assy
Why would the emergency brake light stay on when the emergency brake is not in use on a 1986 Chevy Nova?
Bad switch on the emergency brake handle.
1986 S-10 brake lights not working?
Check the fuse, check the bulbs and check the brake light switch.
How do you test a brake light switch on a 1986 diesel Mercedes?
have someone press it down and have the other check the lights in the back
Why do the brake lights stay on on my 1986 Honda aspencade?
Bad brake switch
Where is brake light switch on a 1986 Cutlass?
There should be a bracket mounted on the steering column near the floor. This will have a switch in it that is a plunger type. When the shaft of the brake pedal is depressed, it comes into contact with this plunger and activates the brake light circuit. If you "ride the brakes", your brake lights will always be on because of the minimal pressure required to activate this circuit.
Why would pushing the brake on 1986 300zx make you lose electrical power?
Check for a short in the brake light circuit. A dead short will dim lights & blow fuses. Have you checked the charging system & battery? Pull the fuse for the brake lamp circuit & see if the same problem still exists.
