0
What else can I help you with?
How do you replace the camshaft position sensor on a 1997 Plymouth voyager 3 L?
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
Where is the camshaft position sensor located on a 1997 rs camaro?
The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.
How do i install a 1997 dodge caravan 3.0 camshaft position sensor?
If I'm not mistaken, I think the camshaft position sensor on these engines is built into the distributor. You'd have to replace the whole thing.
Where is the crankshaft position sensor on a 1999 Chevy Venture and how do you change it?
Where is the camshaft sensor located in 1997 Chevy venture
Where is the camshaft position sensor located on a 1997 GMC Sierra?
its located in the distributor at the back of the motor.
Where is the camshaft position sensor located on a 1997 Chev S10 pickup with a 4.3 liter V6?
On the 97 s series trucks with the hvs, The camshaft sensor is located inside of the distributor.
Where is the camshaft position sensor on a 1997 vw golf 2.0 code po341?
Behind the cam gear
Where is the camshaft position sensor on a 1997 Honda Passport 2wd?
have you checked inside the distributor . good luck
What does the code P0340 mean on a 1997 pylmouth voyager?
P0340 Camshaft Position Sensor Circuit Malfunction
Where is the Gm 3800 series 3 crank position sensor located?
Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor
What does the code p 1345 mean for a Chevy 1997 pickup?
Code P1345 is for the crankshaft or camshaft position sensor.
How do you replace the camshaft position sensor on a 1997 land rover discovery?
To replace the camshaft position sensor on a 1997 Land Rover Discovery, first disconnect the battery to ensure safety. Locate the sensor, which is typically found on the engine block near the camshaft. Remove the electrical connector and the mounting bolts, then take out the old sensor. Install the new sensor by reversing the removal steps, securing it with bolts, reconnecting the electrical connector, and finally reconnecting the battery.
