0
Best Answer
It is bolted in the passenger side of the engine block RIGHT BEHIND the starter. You can not see or get to it untill you remove the starter.
Wiki User
∙ 12y agoThis answer is:
Add your answer:
Earn +20 ptsQ: Where is crank sensor on 03 Chevy 2500 hd truck?
Write your answer...
Submit
Still have questions?
Related questions
Where is a crank sensor on 2000 dodge 2500 5.9?
in the distribuator
Does a faulty oxygen sensors cause a truck to run bad on a 1988 Chevy 2500?
yes it can. also check knock sensor and the wire going to it
Where is the carb located on a 2001 Chevy 2500?
there is no carb on that truck
Oil capacity for 2008 Chevy truck?
Oil capacity 2008 Chevy 2500
Where is the inertia switch on a 1999 Chevy 2500 truck?
It does not have one. Chevy did not use them on there trucks.
Do the 1500 2500 3500 Chevy truck have the same engine?
They could.
Where is the 02 sensor on a 1994 Chevy 2500 truck?
It is screwed into the exhaust pipe close to were the pipe bolts to the engine. It is about 3 to 4 inches long with an electric wire pluged to it.
How do you Install tow truck bed on to Chevy truck 2500?
can a tow bed be wielded to frame of a truck or does it have to be boilted down
Will a transmission from a 2000 Chevy 2500 truck work in a 2005 Chevy 3500 express van?
Yes.
What size is the fuel tank on a 2000 Chevy truck 2500 series?
On a 2000 Chevy 2500 HD Durmax Diesel, the tank size is 22 gallons.
Is there an inspection plate for the heater core of a 1995 Chevy 2500 truck?
sgsdgsfgsg
How much does a Chevy 2500 truck bed weigh?
around 500 pounds
Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.