Park the blazer on a flat surface and remove the keys from the ignition. Locate the instrument panel fuse block on the underside of the steering wheel, close to the brake pedal.
Remove the cover from the instrument panel fuse block by turning the fastener counterclockwise. On the underside of the cover, you will find a fuse extractor.
3
Remove the daytime running lamp fuse using the fuse extractor. The daytime running lamp fuse is the fuse numbered "15."
Place the fuse extractor back onto the cover and place the cover back onto the fuse block. Without the DRL fuse, the daytime running lamps will no longer function properly. To enable the DRLs, simply install a new 15A fuse
inside the intake attached to the injector module
Need to replace the ingnition module in the distributor.
A '96 jimmy does not have a body control module (bcm), it does, however, have an engine control module (ecm) located ontop of the coolant reservoir.
In our 96 Blazer S10, it was behind the radio. We had to remove the radio to get to it.
inside the distributor
Could be a bad fuel filter or ignition coil/module.
Underneath the rotor in the distributor. Crazy I know...
dont think it has one, or dose it,
The fuel pump is located inside the fuel (gas) tank
Fit 96 grill in 95 blazer
If you go to the front of you Blazer and look underneath the bumper you will find an access panel for your oil filter
It is located on the rear axle. Remove the spare tire to see it easier.