0
What else can I help you with?
Where is knock sensor on 01 silverado?
Need to know the engine size. YOU will need to ASK your question again. THANK YOU.
Where is a knock sensor on a 01 Chevy silverado 4.8?
on a 99 model there are two of them and its located under the intake. quite a bit of work but not bad.
When was Knock Knock - album - created?
Knock Knock - album - was created on 1999-01-12.
How do you replace knock sensor on Lexus ls 430 01?
To replace the knock sensor on a 2001 Lexus LS 430, first disconnect the negative battery terminal to ensure safety. Then, remove the intake manifold to access the knock sensor, which is located on the engine block. Disconnect the wiring harness from the old sensor, unbolt it, and install the new sensor, ensuring it's properly torqued. Finally, reassemble the intake manifold, reconnect the battery, and start the engine to check for any error codes.
When did Knock First end?
Knock First ended on 2004-10-01.
Will the front bumper of a 03 Chevy 2500 fit on a 01 Chevy 2500?
Yes
Where is the Temp sensor location 01 durango 4.7l?
coolant temp. sensor- front of motor on intake manifold intake air temp. sensor- right side of throttle body, on valve cover i believe
Where is the knock sensor located on a 01 Chevy silverado z71 with a 5.3 engine size?
That engine has 2 of them and believe it or NOT. they are UNDERNEATH the intake manifold. You will have to remove the intake to even SEE them are to service them.
Where is the oxygen sensor on an 01 Audi A6 quatro located?
In a very difficult location since there are four. Get the car up on a hoist to do it.
Need a diagram of location of 01 ford mustang cylinder temperature sensor 3.8 L?
Right above the thermostat housing..
How do you replace a knock sensor and where is it located on an 01 GMC Yukon?
the knock censors are located under the intake. something you need to know when you change the knock censors you need to-take some high temp silicone and build a levee to make the water flow around the censors that is what makes them go bad also check the harness while you have it down
Where is the Location of crankshaft sensor for 5.9 Cummings?
In my 01, it's a camshaft sensor under the transfer pump. On some, behind the starter motor in the block. It depends on the year model--get a Haynes manual for your year.
