On a 1997 Chrysler Sebring, the leak detection pump is typically located near the fuel tank, attached to the fuel pump module or mounted on the top of the fuel tank itself. This component is part of the evaporative emission control system, which helps detect leaks in the fuel system. To access it, you may need to lower the fuel tank, as it is not easily accessible from the top of the vehicle.
The leak detection pump pressure switch is located next to the service vacuum supply. It will be connected to the LDP filter and below the EVAP canister.
The leak detection pump is next to the steering gear, under the van, below the driver side floor board.
Leak detection pump switch or mechanical failure
Yes.
The LDP (Leak Detection Pump) is located above the fuel tank. You'll have to remove the fuel tank to get to it.
probably the coolant tube under the manifold. it is only available from the dealer
The leak detection pump switch on your Dodge Intrepid is located beneath the battery. If you can not locate this on your own, it may be best to have a licensed mechanic take a look at it.
It is located behind the gas tank
American Leak Detection was created in 1974.
American Leak Detection's population is 30.
It is located on top or around the gas tank.
possible faulty leak detection pump