0
What else can I help you with?
When should timing belt changed on 98 town and country?
A 1998 Chrysler Town and Country has a timing chain which does not have a service interval.
98 town and country stalls to go until engin warms up?
replace your mapp sensor
Where is the body control module located on a 98 Chrysler town and country?
Under the lower left of the dash. behind the under dash fuse box.
Town and country 98 alarm system wont quit shutting down the van?
Need to take van to a Chrysler dealer and have alarm system retrained.
What is the meaning of the P1391 code 98 Chrysler sebring convertible?
1391 is for an intermittent loss of the cam sensor or crank sensor signal
Where is the oxygen sensor located on a Chrysler cirrus 98?
There are two, one on each side of the catalytic converter.
98 Chrysler town and country run hot and hard to steer and the battery light came on.?
Your belt has probably fallen off. You need to get that repaired before you ruin the engine by overheating.
How much does it cost to replace the timing belt of a 98 town country Chrysler mini van?
If you have a 3.3 or 3.8L V6 engine, they use timing chains and not belts, so they do not need to be replaced.
Where is the O2 sensor located in 98 Chrysler Concorde?
There are 4, one before and one after each catalytic converter in the exhaust.
Where is the crank shaft sensor on a 98 Chrysler Cirrus?
the crankshaft sensort is at bottom under the distrbutor it is way down there by the trans housing.
Where is the heater blower relay switch 98 Chrysler town and country?
In a 1998 Chrysler Town and Country, the heater blower relay switch is typically located in the fuse box under the hood. You can find the fuse box near the driver’s side of the engine compartment. The specific relay for the blower motor may be labeled on the lid of the fuse box. Always consult the vehicle’s owner manual for detailed diagrams and information.
Where is the bank 1 sensor 1 o2 sensor located on a 98 town car?
Bank 1 on that Town car would be the passenger side of the engine. Bank 1 Sensor 1 would be the first O2 sensor in the passenger side exhaust after the engine but before the catalytic converter.
