0
What else can I help you with?
Where is the AC sensor on a 1999 Chevy Blazer?
no such thing
Locating crankshaft sensor for 1999 Chevy blazer?
The crankshaft sensor on a 1999 Chevy Blazer is located on the bottom of the engine, near the oil filter. It connects to the vehicle's computer and constantly updates it on the crankshaft's position.
Which oxygen sensor should you change on your 1999 Chevy blazer back firing problems?
If it had a bad O2 sensor the "check engine" would be illuminated and a code would be set indicating which sensor is at fault. You probably have other problems causing that backfire to occur.
Where is the oxygen sensor bank1 sensor 3 on a 1999 chevy s-10?
That would be the O2 sensor after the catalytic converter.
When should you have your timing belt replaced on your 1999 Chevy blazer?
Your 1999 Chevy blazer doesn't have a timing belt.
Will a 1997 Chevy blazer work on a 1999 Chevy blazer?
Will a 1997 blazer what work on a 1999 blazer????? If your talking engine, transmission, or running gear than yes. It is all the same.
Where is the oxygen sensor on a 1999 Chevy s10 4.3?
That vehicle has several oxygen sensors and they are all threaded into the exhaust at various points.
How do you drain the torque converter on a 1994 Chevy s10 blazer?
how to drai torque converter on 1999 chevy blazer
Is the wiring the same in a 1999 Chevy blazer the same as a 2001 Chevy blazer?
Mostly, yes.
Will your 1995 Chevy Blazer transmission fit on your 2003 Chevy Blazer?
NO. Not even close. Chevy redesigned ALL the TRANSMISSIONS and ENGINES in late 1999. Anything above 1999 WILL NOT FIT anything under 1999.
Where is the Cam Shaft position sensor on 1999 Chevy?
1999 Chevy what? What kind of 1999 Chevy. different models have different sensor positions
Where is the Vehicle Speed Sensor and how do you replace it on a 1999 Chevy blazer?
The Vehicle Speed Sensor (VSS) on a 1999 Chevy Blazer is typically located on the transmission, near the tailshaft. To replace it, first disconnect the negative battery cable, then remove the electrical connector from the sensor. Next, unbolt the sensor from the transmission and pull it out; install the new sensor in reverse order, ensuring a tight seal and reconnecting the electrical connector. Finally, reconnect the battery and test the vehicle to ensure proper operation.
