answersLogoWhite

0

You may be able to get the answer at our forum. If you are looking for the reset to be able to get the key out of the ignition then it is right below the ignition switch on the steering column. The problem is you have to drill or cut a hole in the plastic to make it visible.

We have pictures at the forum to make it easier.

www.trailvoy.com

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do i reset the Fuel pump switch for 2003 Chevrolet trailblazer?

Chevrolet does not use inertia/reset switches.


Location of tire pressure monitor reset switch on 2005 sequoia?

Under the steering wheel column, about even with the dashboard. Recessed in little hollow area.


Where is the safety switch that shut off the fuel pumps on a F250 Ford truck in an accident?

Try checking the floorboard to the left an above where the steering column passes through the floorboard. There's a reset button on top of the switch.


Where is the maintenance required combination meter located in a Mitsubishi Mighty Max?

there is a small switch behind one of the switch blank off plates to the right of the steering column. It is a very small switch about 6" deep into the dash, hard to find easy to reset.


Where is the Chevy Trailblazer fuel pump reset switch?

No reset switch only a relay under hood in the control center. 95% of the time the fuel pump is shot.


Fuel pump reset switch 1985 Lincoln town car?

The 1985 Lincoln Town Car fuel pump reset switch can be found in the fuse box. The reset switch will be at the bottom of the third column.


Where is the Airbag Reset Switch on the Nissan Quest 2005?

The airbag reset switch on a 2005 Nissan Quest is typically located underneath the dashboard on the driver's side. It may be found near the steering column or around the area where the pedals are located. Look for a small, usually red or yellow switch that may be labeled for airbag reset functions. Always refer to the owner's manual for specific details regarding your vehicle.


How do you reset service light on integra?

there is a button underneath the steering column that needs to be held in for a couple of seconds.


1992 tracker with 100000 miles check engine light came on how do turn it off?

Hi, You need to look on the steering column support to the left side of the dashboard or to the left speaker. The lamp can be reset by moving the switch up and then down. If the light stays on after you reset the switch, then there is a problem in the system. Good luck. Steve H.


How do you reset 2001 suburban alarm kill switch?

To reset the alarm kill switch on a 2001 Chevrolet Suburban, first ensure that the vehicle is in the "Off" position. Next, locate the alarm disable switch, typically found under the dashboard or near the steering column. Press and hold the switch for a few seconds, then release it. Finally, turn the ignition to "On" and start the vehicle to see if the alarm is reset. If issues persist, consult the owner's manual or a professional mechanic for further assistance.


Where is the check engine light reset on a 1990 Geo Tracker?

AnswerHi, If your vehicle has a switch, it should be under the dash, on ther left side on the steering column support or to the left of the speaker. The lamp can be reset by moving the switch up then down. If the light remains on then check the system. Steve H. or DISCONECT the battery for 30 sec then reconect


What to do if your gauge says it is over?

Reset the whole thing and there should be a little red switch which says reset in the boot or on the steering wheel