It is on the passenger side of the engine compartment right in front of the coolant reservoir. The shiny long refrigerant line has the port covered with a screw off cap.
The low pressure connection for your 1993 Jeep Cherokee air conditioning system is located on the top of the air conditioning compressor. There is a low pressure connection and a high pressure connection, both should be labeled.
On the back of the engine, next to the distributor.
The 1993 Jeep Grand Cherokee engine control module is located on the firewall in the engine compartment. The engine control module will be on the passenger side of the firewall.
Its part of the liquid line on a Grand Cherokee and on a regular Cherokee you have an expansion valve located on the passengers side firewall..................
The low pressure port on a 1993 Ford Ranger is located close to the firewall. It can be seen just under the air filter housing.
Its located behind the front bumber on the drivers side. Under the turn signal lamp.
On a 1993 Jeep Cherokee, the Powertrain Control Module (PCM) is typically located under the dashboard on the driver's side, mounted to the firewall. It can be accessed by removing the lower dash panel. Be cautious when handling the PCM, as it is sensitive electronic equipment.
It is made into the liquid line, you have to replace the line to service.
On a 1994 Grand Cherokee, it is located behind the driver-side kick panel. Maybe that will get you started.
Jeep does not use inertia/reset switches.
driver front on inside of fender next to airbox
The "flasher fuse" Is located in the fuse panel.It is a round relay fuse