Haynes Repair Manual #36071: 1995 and later models use the Electronic Engine Control (EEC-V) system that consists of a Powertrain Control Module (PCM) and information sensors which monitor various functions of the engine and send data to the PCM. Based on the data and the information programmed into the computer's memory. The EEC-V diagnostic connector is located under the dashboard close to the steering column. A scan tool must be used to retrieve the codes. The PCM is located on the passenger's side of the engine compartment along the upper edge of the firewall.
Where is the computer located in the 1995 ford e250 4.9l engine
The computer on a 1993 Ford Ranger is located in the dash in the center just above the transmission hump. The computer is located just below the heater control panel.
The 1997 Ford Ranger ECM computer is located behind the dashboard. The computer will be on the passenger side of the passenger compartment.
On a 1995 Ford Ranger : The heater blower motor is in the ENGINE COMPARTMENT , near the firewall , on the passenger side of the engine
The fuel pump relay for the 1995 ford ranger 2,3 is located under the hood. It is in the power distribution box.
in the gas tank
check
Where is the water temperature sender 1995 ford ranger 2.3?In: Ford [ranger]
On a 1995 Ford Ranger : The ODOMETER is near the center of your speedometer
On a 1995 Ford Ranger # 17 fuse is for the cigarette lighter.
There are 3 plugs on each side of the engine.
drl module location on a ford ranger 1995