0
The EGR valve On the 4.3 engine vin W It's right below the air intake on the intake manifold. Mounted with two bolts, and has one electrical connector (4 wires) I have a 94 s-10 that for the last week is acting like a Ford (fix and repair daily). Symptoms are rough idle, lurching when the RPM's drop below 1.2k, loss of POWER brakes when rolling up to a stop sign and service engine soon light. When you check the codes it gives a 32. Found that pieces of loose carbon the size of small stones are getting caught between the valve and valve seat not allowing it function correctly. I
What else can I help you with?
Where is the PCV valve on a 1996 Chevy Camaro 3800 v6?
On a 1996 Chevy Camaro, the PCV valve is located on the right side of the valve cover. There is a hose that runs from the PCV valve and connects to the back of the intake manifold.
Will a steering wheel from a 1996 Chevy pickup fit on a 1970 Chevy pickup?
NO it will not.
Where is the PCV valve on a 1996 Chevy Tahoe located?
It is in a hose that is stuck in the top of the drivers side valve cover.
Where is the EGR valve located on a 1996 Chevy Silverado?
It is in the middle between the intake and the water pump.
Where is the ecm located in a 1996 Chevy s10 pickup?
Under the hood, on top of the passenger side inner fender.
On a 1996 Chevy Suburban the brake system incorporates a dump valve What does this dump valve do and or where is it?
The brake dump valve on a 1996 Chevy Suburban is used for bleeding the brakes after new brake pads are installed. It is located on the master cylinder for each brake.
Where on a 1996 Chevy pickup 4.3?
Where what! What is your question?
Where is the starter located on a 1996 Chevy Cheyenne pickup?
Try the lower rear of the engine - try to follow the + battery cable
Where is the alternator located on 1996 Chevy s-10 pickup truck?
You would find it in the front of the engine driven by the accessory belt.
Where is PCV valve locate on 1996 s-10 pickup?
On top of the valve cover on the passenger side
Will a 1996 Chevy s-10 4x4 transmission fit a 1996 Chevy 4x4 1500 pickup?
NO it will not. The bell housing is different.
Where is the 4 wheel drive actuator located on a 1996 2500 Chevy pickup?
It is screewed into the front Differential, towards passenger side but in the middle of the housing.
