answersLogoWhite

0

The FWD solenoid is just to the left of the battery and mounted on the inside of the finder. It is a cylinder about 2 inches tall with at least 2 large posts and maybe a small one. There should also be red wire runing from the pos. batter terminal over to the solenoid... Good luck

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Will the starter solenoid from a 1992 Ford Bronco fit on a 1994 Ford Explorer?

Yes ( Motorcraft SW1951C )


Where is the starter solenoid located on a 2001 Ford Explorer Sport?

The starter solenoid is mounted directly to the starter.


How much does it cost to replace a solenoid in a Ford Explorer?

It will cost approximately $60 to replace a solenoid in your Ford Explorer. The exact cost is dependent upon which solenoid is to be replaced.


Where is the starter solenoid on a 1991 Ford Explorer?

It is located on the passenger side fender firewall behind the battery.


Will a door on 1998 Ford Explorer 2door fit on a 1992 Ford Explorer?

No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.


Your 1994 Ford Explorer will not start the starter was tested and the battery is good there is a click from the relay but that is all?

you need to replace the starter solenoid usually on a ford the solenoid is located on the side of the engine bay


How do you replace evaporator on a 1992 Ford Explorer?

How do you replace evaporator on a 1992 ford explorer?"


Where is the mass air flow - MAF - sensor relay located on 1992 Ford Explorer?

The Mass Air Flow sensor is located on top of the air filter housing on Ford Explorer.


Where is the fuel pump located in a 1992 Ford Explorer XLT?

Inside the fuel tank


Where is the shift solenoid on a 98 ford explorer?

on the bottom of the transmission


Where is the starter solenoid located on a ford explorer 2004?

On a 2004 Ford Explorer, the starter solenoid is typically located on the starter motor itself, which is situated near the bottom of the engine, close to the transmission. To access it, you may need to lift the vehicle or remove components like the air intake duct for better visibility. The solenoid is usually a cylindrical component attached to the starter, with battery and ignition wires connected to it.


How do you remove ignition switch from 1992 Ford Explorer?

Type your answer here... How do you remove ignition switch from 1992 ford explorer?