The computer module, also known as the Engine Control Module (ECM) or Powertrain Control Module (PCM), for a 1999 Ford Explorer XLT is typically located in the engine compartment. It's usually mounted on the passenger side, near the firewall, or close to the battery. To access it, you may need to remove some components or covers, depending on the specific configuration of the vehicle. Always consult a repair manual for detailed instructions and safety precautions.
The 2007 Ford Explorer computer module is located below the dashboard, on the passenger side. The computer module is in a rectangle steel box.
at the left side of rear compartment where the jack is. on the sticker of the the yellow box.
On a 1994 Ford Explorer, the computer module is behind the kick panel on the passenger front side.
The computer module for the keyless entry system on the 2006 Ford Explorer is behind the rear passenger seat. It is located under the seat belt panel.
The Ford Explorer computer module is located on the firewall under the hood in the center on some models. On other models the computer module is behind the glove compartment. The glove compartment has to be removed (open it as far as possible to pop it off the back hinge) to access the computer module.
it is on the transfer case
The idle is controlled by the powertrain control module ( computer )
Need to replace computer on 1997 ford explore. Need to know location of computer?
Ford Explorer 1991-2001 Under hood, drivers side in firewall
On a 2001 Ford Explorer the airbag control module is located behind the passenger side kick panel (located to the right of the passengers right foot if seated in the vehicle).
where does a shift module go in at on a 1995 ford explorer xlt 4.0 2wd
The powertrain control module on 1991 and 1992 Ford Explorer is in the right front passenger area behind the right front kick panel