It is located on the reciever\dryer by the passenger side firewall.
were is the low pressure side ac port located on 2002 lincoln navigator
It is located on the left side of the valve cover under the wires you will see the low port I hope it helps ....
on the big silver cannister( dryer ) under the hood on the passenger side firewall
The schrader valves on the high and low side are always kept accessible without the requirements for components to be removed. Refer to your owner's manual for the location.
low pressure recharge port is on reciver/dryer under brackets by battery. easier to get to if you remove part of the bracket, but it can be done without that if you have small agile hande. the high pressure port is by battery close to front of truck
The diagnostic connector is under the dash on the driver side.
In a 2004 Lincoln Navigator, the OBD-II port is located under the dashboard on the driver's side. Specifically, you can find it to the left of the steering column, near the area where the lower dashboard meets the instrument panel. It may be necessary to remove a cover or panel to access the port.
On a 1999 Lincoln Continental, the low-pressure port for the air conditioning system is typically located on the larger diameter aluminum line that runs between the compressor and the evaporator. It is usually near the front of the engine bay, close to the firewall, and may be covered by a plastic cap that is often labeled with an "L" for low pressure. Always ensure the engine is off and the system is depressurized before attempting to locate or service the port.
You can recharge your 2004 Lincoln LS from the low pressure port. The low pressure port can be found on the top of the air conditioning compressor.
To recharge the air conditioning system with Freon in a 2000 Lincoln Navigator, first, locate the low-pressure service port, which is typically found on the larger diameter A/C line. Ensure the engine is off and connect the refrigerant can’s hose to the port. Start the engine and turn the A/C to the maximum setting, then slowly open the valve on the refrigerant can to add Freon until the system is adequately charged, monitoring the pressure gauge if available. Always follow safety precautions and consider consulting a professional if you're unsure.
what port had been the home of prince henry the navigator
Look under the wiring harness between the battery and engine fairly close to the firewall.