0
What else can I help you with?
Where can you find a site for troubleshooting 1983 Nissan Sentra transaxle problems?
Autozone.com
Are engine and interior parts from 1983 Pulsar 1.6L interchangeable with the same from a 1983 Nissan Sentra?
Most parts are with a little creative adjustments
1983 Nissan Maxima where is the flasher located on 1983 Nissan Maxima?
The 1983 Nissan Maxima is equipped with for flashers, one on each corner of the vehicle. The flasher relay switch is located beneath the dashboard in the passenger compartment.
Where is the EGR valve located in a 1983 Buick Electra?
located around intake area...
Where is the clutch bleeder valve on a 1983 Nissan 720 pickup?
It should be down below where the slave cylinder connects to the tranny
Where is the PVC valve located on a 1983 Honda Civic sedan and how do you replace it?
The 1983 civic, hatchback with 1.5 engine does not have one.
Would a clogged EGR valve cause a loss of power and poor gas mileage on a 1983 Nissan pickup?
Yes, most definitely.
How do you do valve adjustment on 1983 Nissan Datsun 200sx?
To adjust the valves on a 1983 Nissan Datsun 200SX, first ensure the engine is cold. Remove the valve cover and use a feeler gauge to check the clearance between the rocker arm and the valve stem for each cylinder. Adjust the clearance by loosening the lock nut on the rocker arm and turning the adjustment screw until the correct clearance is achieved, then retighten the lock nut. Repeat this for all cylinders, then reassemble the valve cover.
Where is the PCV valve located on a 1983 Buick Electra Park Avenue?
Hey Chris==It is in the right valve cover. There should be a hose from it to the intake or carb. GoodluckJoe
Where is the EGR valve located on a 1983 Mercury Grand Marquis 5.0?
passenger side fender wall,it should have two hoses connected to it
How do you adjust the valves on a 1983 Nissan 280ZX?
To adjust the valves on a 1983 Nissan 280ZX, first, ensure the engine is cold. Remove the valve cover and locate the rocker arms. Using a feeler gauge, check the clearance between the rocker arm and the valve stem; it should be set to the specifications outlined in the service manual (typically around 0.008 inches for intake and 0.010 inches for exhaust). Adjust the clearance by turning the adjusting nut on the rocker arm until the desired gap is achieved, then recheck with the feeler gauge and reassemble the valve cover.
When was Yaniv Ben-Nissan born?
Yaniv Ben-Nissan was born on 1983-08-22.
