Look at the upper end of the brake pedal under the dash area. This how to change the switch. I just did mine with a help of a friend.
First,remove the plastic panel from underneath the steering column (do not forget to remove two screws holding the hood release latch)and the supporting metal bracket.
Second, remove two screws for a switch mounted on the steering column and 2/3 of the way where the brake paddle touches.
Third, now uoy have a clear way to remove the swich, remove the connector and looses the nut it is a little bit hard because the space is tight but with patience you will get it
Finally, put the new switch on and good luck with putting all the screws back wher they belong. Tools you need a philips, straight screw drives, 10" and 12" socket. a 10,12,13 and 14 MM renches.
The location for the idle switch of a 1992 Toyota Previa mini van can be found in the Toyota Previa Auto Repair Manual 1991 thru 1995. This can be purchased from the Toyota dealership.
To change the headlight switch on a Toyota Previa, first, disconnect the negative battery terminal to ensure safety. Next, remove the steering column covers by unscrewing the screws and gently prying them apart. Locate the headlight switch connector, disconnect it, and unscrew the switch from its mounting. Finally, replace it with the new switch, reassemble the column covers, and reconnect the battery.
If your heating switch broke on the heater of a Toyota Previa 92, it will need changed. You can find a replacement at auto part stores.
Answer: busted door switch/switches.
.....still lookin'
if i can remember right and most Toyota are the same around the 1993 and 1996 range ,you will find the signal relay switch behind the dash ,
Toyota previa fuse box located in the top center of the dash. look near where the air conditioning switch should be. you will see a small tab press this and lift the entire top panel up
try checking main fuse box located in top of dashboard release clip located just above where the ac switch is (or would be if the vehicle doesnt have ac fitted)
In a 1992 Toyota Previa, the inertia switch is typically located in the engine compartment, mounted on the driver's side near the fender. It is designed to cut off fuel supply in the event of a collision. To access it, you may need to remove some covers or panels in the area. Always refer to the vehicle's manual for specific location details and safety precautions when working on the vehicle.
In the Toyota Previa, the switch for the fog lights is typically located on the dashboard, near the headlight controls. It may be a separate toggle or button, often marked with a fog light symbol. In some models, the fog light function can also be activated by pulling the headlight switch outward. Always refer to the vehicle’s owner manual for the exact location and operation.
To replace the switch in a 1993 Toyota Previa, start by disconnecting the battery to ensure safety. Remove the trim around the switch using a flathead screwdriver or trim removal tool, then unscrew the switch from its housing. Disconnect the wiring harness from the old switch and connect it to the new switch before securing it back in place and reassembling the trim. Finally, reconnect the battery and test the new switch to ensure it functions correctly.
how do you change turn signal switch on 1999 toyota camry