On my 1998 Aurora with 4.0L v8, the air intake temperature sensor is located on the air filter housing on the driver's side of engine compartment.
The starter on this car is located under the intake manifold, in the engine valley. Tech JK -------------
The cooling sensor, also known as the coolant temperature sensor, on a 1999 Oldsmobile Aurora is typically located near the engine block, usually on the intake manifold or near the thermostat housing. This sensor monitors the temperature of the engine coolant and sends data to the engine control unit. For precise location, consulting a repair manual or service guide specific to the 1999 Aurora is recommended.
check intake plenum boot
On my 1999 it is below the air intake filter assembly on the right side. Type your answer here...
On a 1998 Oldsmobile Aurora, the temperature sensor, also known as the coolant temperature sensor, is typically located near the engine, specifically on the engine block or cylinder head. It is usually positioned near the thermostat housing or the intake manifold. To access it, you may need to remove certain engine components for better visibility and ease of replacement. Always refer to the vehicle's service manual for precise location and procedures.
under the intake manifold you have to remove the engine cover to get to it.
Remove the intake manifold. The starter is underneath.
The mass air flow (MAF) sensor on a 2001 Oldsmobile Aurora is typically located in the intake air duct, between the air filter and the throttle body. To access it, you may need to remove the air intake hose or ducting. Always ensure the engine is off and cool before attempting to locate or service the sensor.
The air control valve on a 2001 Oldsmobile Aurora is typically located near the throttle body, integrated into the intake manifold assembly. It helps regulate the air intake for the engine. To access it, you may need to remove any components obstructing the throttle body, such as the air intake hose. Always consult the vehicle’s service manual for specific details and safety precautions.
The Oldsmobile Aurora, which was produced from 1995 to 1999, does not have a carburetor as it is equipped with a fuel-injected engine. Instead, it uses a multi-port fuel injection system that delivers fuel directly into the combustion chambers. If you're looking for engine components, the fuel injectors are located near the intake manifold, which is situated on top of the engine.
It's under the intake manifold. Remove that & the starter is accessible.
The knock sensor in a 1997 Oldsmobile Aurora is located on the engine block, specifically on the lower part of the engine near the cylinder heads. It is typically positioned on the driver's side, between the intake manifold and the engine block. To access it, you may need to remove some components, as it can be somewhat difficult to reach.