The ambient temperature sensor for the Aurora heater is typically located near the base of the unit or within the control panel. Its placement allows for accurate readings of the surrounding air temperature, which is essential for the heater's operation and regulation. Always consult the specific user manual for the exact location, as it may vary by model.
The airflow ambient temperature sensor is located on the air intake housing. The sensor should be labeled as the airflow ambient temperature sensor.
were is the location of the ambient air temperature sensor for a 2001 bmw 330 i
The ambient air temperature sensor, on your Nissan automobile, is located in the drivers side mirror. The sensor is on the bottom of the mirror.
I posted pictures on the location and replacement of an ambient temp. sensor for a 2001 S40. Google "ambient temperature sensor location/replacement" or go to Matthew's Volvo site and search there.
The 1995 Oldsmobile Aurora cooling system temperature sensor can be found on the front of the engine. The sensor will be above the thermostat housing.
To measure ambient temperature, you can use a thermometer or a temperature sensor placed in the area you want to monitor. It's important to place the sensor away from direct sunlight or sources of heat to get an accurate reading. Ambient temperature is the surrounding temperature of a specific environment.
No, the MAPP sensor (Manifold Absolute Pressure Sensor) and the ambient temperature sensor are not the same. The MAPP sensor measures the pressure within the intake manifold to help determine engine load and fuel delivery needs, while the ambient temperature sensor measures the outside air temperature. Each sensor serves a distinct purpose in the vehicle's engine management system.
Tamb (K): sensor (ambient) temperature (Kelvin)
The ambient temperature sensor is located behind the front grill.
on the (7 Olds Aurora it is in tront of Radiato in the air inlet area acessable from under front of car it just clips on
On the 2000 town car, the ambient temperature sensor is under the hood. More precisely, behind the grill mounted to the upper radiator support.
The Ambient air temperature is monitored by the Electronic Vehicle Information Center (EVIC) through ambient temperature messages received from the Body Control Module (BCM) over the Programmable Communications Interface (PCI) data bus network. The BCM receives a hard wired input from the ambient temperature sensor. The ambient temperature sensor is a variable resistor mounted to a bracket that is secured with a screw to the right side of the headlamp mounting module grille opening, behind the radiator grille and in front of the engine compartment. The ambient temperature sensor cannot be adjusted or repaired and, if faulty or damaged, it must be replaced.OPERATIONThe ambient temperature sensor is a variable resistor that operates on a five-volt reference signal sent to it by the BCM. The resistance in the sensor changes as temperature changes, changing the temperature sensor signal circuit voltage to the BCM. Based upon the resistance in the sensor, the BCM senses a specific voltage on the temperature sensor signal circuit, which it is programmed to correspond to a specific temperature. The BCM then sends the proper ambient temperature messages to the EVIC over the PCI data bus.The temperature function is supported by the ambient temperature sensor, a wiring circuit, the Body Control Module (BCM), the Programmable Communications Interface (PCI) data bus, and a portion of the Electronic Vehicle Information Center (EVIC) module. If any portion of the ambient temperature sensor circuit fails, the BCM will self-diagnose the circuit. A temperature reading of 130° F will appear in the EVIC display in place of the temperature when the sensor circuit is shorted. A temperature reading of -40° F will appear in the EVIC display in place of the temperature when the sensor circuit is open.