0
if its is a aw4 automatic trans it is the trans range switch it is very expensive but rebuildable look orund on the net for a pic step by step rebulid procedure you basicaly clean the old grease out of it and repack it wit dielectric grease very simple hardest part is adjusting it just right
It is on the same circuit as the brake lights, but if they are not working, and the bulbs are good your switch needs cleaning or adjustment.
Attempt this first since the switch costs nearly $300 bucks.
On the passengers side of the trans just behind the bell housing there is a fan shaped switch, loosen the 12mm bolt ( smaller of the two, and rotate the switch while a friend checks the lights. this problem is usually accompanied by an occasional inability to start the vehicle, but can be cured by jiggling the shifter.
While adjusting the switch make sure that the vehicle will start in park as well, remember to block the wheels while testing the back up lights, engine off, key in run but not start, shifter in reverse, move switch until lights come on.
Once you find this spot, hold it in place and have your helper check to make sure it will start. This may take several tries to get both working correctly.
If you have no luck the switch may be dirty, this happens a lot. Hold the post to the bottom large bolt still while you loosen the nut, then remove it, then remove the 12mm adjusting bolt on top, remove the wire connector and pull the switch away, remove the bolts on the switch and separate the halves, use electrical contact cleaner and maybe some q-tips to clean all the copper connections completely apply di-electric grease and reassemble, refit to the trans and readjust so all functions work, this switch controls back up and start safety.
Caution! always hold that bottom bolt while tightening the large nut, this is connected to the gear adjuster and you could damage the internals if it isn't secured while you do it.
What else can I help you with?
Where is the 94 Jeep Cherokee Sport with i6 inertia switch located?
Doesn't exist
Where is the dashboard dimmer switch located on the 2001 Jeep Cherokee Sport?
The headlight switch to the left of the steering wheel on the front of the dash acts as the dimmer. You spin the switch right or left depending on the intensity of the light you prefer.
Where is the backup light switch on a 96 Jeep Cherokee Sport?
The neutral/back up light switch is located on the passenger side of the transmission close to the rear corner of the housing. It is triangular in shape. Take it apart carefully and clean the contacts with contact cleaner.
Can a neutral switch for a Cherokee limited work on a Cherokee sport?
If both are the same year (yes)
Where is the neutral safety switch located on your jeep Cherokee sport?
under the passenger side of the car on the side of the transmission. it should be in between 2 small pipes.
Where is the airbag light on 96 Jeep Cherokee Sport?
No light on 95-96 cherokee. Thay are a self-contained unit.
Where is the door ajar switch located on the 2008 ford sport?
The door ajar switch on the 2008 Ford Sport is located inside the door that is mounted on the backside.
Where is the EGR Valve located on a 1999 jeep Cherokee sport?
It doesn't have EGR
Where is the fuel pump for a 1992 Jeep Cherokee Sport located?
in the fuel tank
Where is a shift solenoid B located on an automatic transmission It's for a 98 Jeep Cherokee 4x4 Sport.?
The shift solenoid B is located on the engine section on the automatic transmission for the 98 Jeep Cherokee 4x4 Sport.
Where is the reset switch for 2001 Jeep Cherokee Sport 4.0l?
Jeep does not use inertia/reset switches.
How do you replace brake light switch on 2001 Montero sport?
Should be located at the upper end of brake pedal under dash area
