0
What else can I help you with?
Where is the ballast resistor located on a 1989 dodge 100 pickup?
there actually is no ballast resistor on an 89 d-100. Ma Mopar left it out of fuel injected trucks, and 89's are all fuel injected.
Electrical ballast for a 1989 Dodge D-100 getting hot?
If the electrical ballast in your 1989 Dodge D-100 is getting hot, it may indicate an issue such as a poor connection, a failing ballast, or excessive current draw from the ignition system. Overheating can lead to potential failure, so it's important to inspect the wiring and connections for any signs of damage or corrosion. Additionally, ensure that the ballast is compatible with your vehicle's electrical system. If the problem persists, consider replacing the ballast or consulting a mechanic for further diagnosis.
What is the difference between a 1987 dodge D 100 and the D 150 pickup?
A little heavier springs
Can you run a 50 watt halide bulb on a 100 watt halide ballast?
No, it is not recommended to run a 50 watt halide bulb on a 100 watt halide ballast. The ballast should match the wattage of the bulb to ensure proper operation and to avoid potential damage to the bulb and ballast. It is best to use a ballast that is rated for the wattage of the bulb being used.
Where is the oil pressure unit on a 1987 dodge d 100 with a 360?
rear of eng,by distribitor,Pass side
Can a 175 watt metal halide bulb be used in a 100 watt ballast fixture?
No, a 175-watt metal halide bulb should not be used in a 100-watt ballast fixture. The wattage of the bulb must match the ballast's rating for optimal performance and safety. Using a bulb with a higher wattage than the ballast can lead to overheating, reduced lifespan, and potential damage to both the bulb and the ballast. Always ensure compatibility between the bulb and ballast specifications.
When 10 ohm resistor and 100 mega ohm resistor are connected in series then what will be the combined resistance?
100 megohm the 10 ohms completely vanishes in the tolerance of the 100 megohm resistor, in that range tolerances can exceed 20% of nominal.
What is the density of stone ballast?
The density of stone ballast of a standard size is approximately 100 pounds per cubic foot that is 1.6 Metric Tons per cubic.
How many shovels in 1 ton of ballast?
The number of shovels in 1 ton of ballast can vary depending on the size of the shovel and the material's density. On average, a standard shovel can hold about 10 to 15 liters of ballast. Since 1 ton of ballast is approximately 1,000 kilograms, and considering that 1 liter of ballast weighs around 1.6 kilograms, you can estimate that there are roughly 65 to 100 shovels in a ton of ballast.
A 5 ohm resistor a 20 ohm resistor and a 25 ohm resistor are all connected in series to a 100 volt power source The current running through the circuit is?
E/R=I. 100/50=2 amps.
What is the conductance of a 100 ohm's resistor?
0.01 siemens.
How much to replace fluorescent ballast?
The cost to replace a fluorescent ballast typically ranges from $50 to $100, including the cost of the ballast itself and labor for installation. It's recommended to hire a professional electrician to ensure the job is done safely and correctly.
