The temperature valve actuator is located on the front of the heater case
Where is the blend door actuator on a 1998 Sonoma
Where is the blend door actuator located on a 2005 malibu
The blend door actuator on a 2002 GMC Sonoma is typically located behind the dashboard, near the center console area. To access it, you'll often need to remove the glove box and possibly some panels to reach the HVAC housing. The actuator is usually mounted on the side of the heater box and is responsible for controlling the temperature of the air entering the cabin.
To replace the blend door actuator in a 1995 GMC Sonoma, first disconnect the negative battery terminal to ensure safety. Remove the dashboard trim and any necessary panels to access the actuator, which is typically located behind the dashboard on the HVAC module. Unplug the actuator's electrical connector, unbolt it from its mounting, and then install the new actuator by reversing the removal process. Finally, reconnect the battery and test the operation of the new actuator.
The blend door actuator in a 1997 GMC Sonoma is located behind the dashboard, typically near the center of the vehicle, attached to the heater box. To access it, you may need to remove the dashboard or at least the lower dash panel, as it is not easily reachable from under the hood. The actuator controls the flow of air between the heater and the air conditioning system to adjust the temperature inside the cabin.
I believe it is located behind the glove compartment. Drop out the glove compartment box and you will see the blend door actuator.
where is the blend door machanism (acuator) located in my 1998 toyota camryalso how to fix
under the glove box
How do I locate the heater blend door actuator in a Ford f150 pickup
The 1995 General Motors/GMC Sonoma has the door lock motors and actuator assemblies. These are located in the driver and passenger side doors, behind the door trims.
how to replace a blend door actuator on a 1999 ford ranger
You didn't mention what year Blazer you have but in most cases the blend door actuator is located on top of the HVAC box that is located behind the dash assembly. Unfortunately, the entire dash assembly must be removed to gain access to it.