Driver side below the dash and right next to vent it has a hole in it that ties to a shaft inside the vent i think there is two screws that hold it in place.
how to replace a blend door actuator on a 1999 ford ranger
If you are refering to the temp blend door actuator, it is located behind the dash on top of the HVAC box. The dash assembly must be removed to gain access.
The blend door actuator on a 1999 Infiniti I30 is typically located behind the dashboard, near the center console. To access it, you'll often need to remove the dashboard trim and possibly the lower dashboard panels. The actuator is usually mounted to the HVAC housing and controls the airflow temperature by adjusting the blend door. It's advisable to consult a repair manual or guide for detailed instructions specific to your vehicle.
It is located on the HVAC box behind the dash. Unfortunately the dash assembly has to be removed to gain access to it.
I believe you are looking for blend door actuator???
Take old one out put new one in
The blend door actuator in a 1999 GMC Envoy is typically located behind the dashboard, near the heater core. To access it, you may need to remove the lower dash panel and possibly the center console, depending on the specific configuration. The actuator is usually mounted on the HVAC housing, and it controls the airflow temperature by adjusting the blend door. If you're having trouble locating it, consulting a repair manual or seeking assistance from a professional may be helpful.
The blend door actuator can go bad. Big job to replace it. Dash assembly must be removed to gain access to it.
The Blend Door Actuator is stuck or has failed. Somewhat of a common issue.
Bad "blend door" actuator or stuck blend door on the driver's side.
under the battery plate
You will need to remove the dash assembly to gain access to the blend door actuator. Recomend purchasing a shop manual of you intend on doing that job.