It is tucked up in front of the radiator you have to reach in from the front of vehicle
where is de bloc heater on the tucson 2009
It alredy existed -BOOM- Goes the dynamite
There is none on that car.
Possibly. If it has a block heater the cord will be somewhere on the front of the car, easily accessible. Unless it is a Canadian car or it was ordered as an option it will not have one.
To normally install a block heater you must remove an expanstion/ freeze plug in tighten in the block heater. The 6 cylinder 4.2L engine unfortunately does not appear to have any such plugs. The V8 engine should have a screw in style block heater installed in the left front of the engine block just below the cylinder head.
The 2001 Hyundai Santa Fe does not have a factory block heater option. Beginning in 2009 there is a port to install a Hyundai manufactured block heater for cars built for sale in Canada. Pre-2009 requires a heater to go in a freeze-plug hole, so the cord is wherever the installer put it, usually behind grille.
I had one and kept it in the trunk until it was needed
if you have one on your jeep it will be inder the exhaust on the side next to the oil filter.
In a 2009 Hyundai Accent, the engine block heater is typically located on the engine block itself, near the oil pan or the front of the engine. It usually has a power cord that extends out for easy access, often found near the front grille or under the hood. If you're having difficulty locating it, consult the vehicle's owner manual for specific diagrams and details.
On a 2009 Pontiac Montana, the block heater is typically located near the engine block, specifically on the driver's side, towards the front. It is a cord that plugs into a standard electrical outlet, making it easier to start the vehicle in cold weather by warming the engine. If you're having trouble locating it, check under the hood for a cable or plug that may be tucked away or secured to the engine.
The 2009 Ford Escape has 16 valves.