answersLogoWhite

0

It is in the fuse box which is bolted to the headlight switch. You need to remove the headlight switch ti access it.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where do you place jack on a 1963 Ford Falcon futura?

In the trunk


What is the wheelbase of the American built 1963 Ford Falcon Futura?

Wheelbase (in.): 109.5


What is the curb weight of a 1963 Ford Falcon sedan?

2345lbs for the Futura, slightly less in basic trim.


What are the head bolt torque specifications for a 1963 Ford Futura Falcon 6 Cylinder?

1995 falcon futura 4lt engine torque specs for ALUMINIUM HEAD are ; first, 19 ft lb second,30 ft lb third,plus a 90 deg turn on each bolt. follow tightening sequence. retorque after 500 klm.wait till engine cools. note, specs on gasmiser head gasket.


How do you adjust brakes on a 1963 falcon?

To adjust the brakes on a 1963 Ford Falcon, first, loosen the brake drum by removing the wheel and tire. Next, use a brake adjusting tool or a flathead screwdriver to turn the star wheel on the brake assembly. Turn it clockwise to tighten and counterclockwise to loosen until the brake shoes make slight contact with the drum. Finally, reassemble the wheel and tire, and pump the brake pedal to ensure proper function before taking the car for a test drive.


Where is the brake light switch on a 1963 ford galaxie 500?

underneath the master cylinder


Where is the brake light switch on a 1963 Galaxie 500?

The brake light switch is threaded into the master cylinder. Open the hood, look at the brake master cylinder, notice the brake light switch with wires connected. Have new one ready to install when you remove the old one to keep loss of brake fluid to a minimum.


Brake light flashing on dash of 1963 Chevy impala can't get it to stop The light that is. brakes working fine.ANY SUGGESTIONS?

could be that the emergency brake cable is stretched and the pedal has fallen down a bit.try lifting up on your emerg brake pedal


What city was the 1963 American Ford Falcon made in?

Detroit, Michigan.


How many 1963 ford falcon 2 door station wagons were built?

Approximately 27,000 units of the 1963 Ford Falcon 2-door station wagon were produced. The Falcon was part of Ford's compact car lineup, which gained popularity for its affordability and practicality. The 1963 model year was significant, as it marked the introduction of several variations in the Falcon range. However, exact production figures can vary slightly depending on the source.


When was Colin Brake born?

Colin Brake was born in 1963, in England, UK.


How do you release emergency brake?

how do i release the emergency brake on a 1963 ford thunder bird?