fuel injected there is no carb
I had the same problem with my 98 jimmy I repalaced the water pump have had heat since.
To change the camshaft positioning sensor on a 98 GMC Jimmy you need to first locate it. The sensor is located within the distributor. Next, unbolt the old sensor and replace with a new sensor.
May have to take the truck to a certified speedometer repair shop
master cylinder or power booster
threw the stater hole with of coarse the starter removed.
It's in a plastic trap door in between the the radiator and the oil drain pan.
GM vehicles are not equipped with a fuel pump inertia switch.
yes with a lot of work.i have done it myself.contact advanced adapters
The 98 S10 doesn't have a carburetor.
The 1998 GMC Jimmy air-conditioner low pressure for is located on the top of the air conditioner compressor. The low pressure port will be marked as such.
Rear brake hose, but their are 2 models. 1 is RJ2 that has a banjo bolt.
I have a 2000 Jimmy and just had to have new ball joints put in yesterday for the same problem and then had an alignment done on it today.