In a 1995 Aerostar, the clock button is typically located on the dashboard, near the radio and climate controls. It may be labeled as "CLK" or "SET" and is used to adjust the time display on the vehicle's clock. To set the clock, you usually press the button and then turn a dial or press additional buttons to change the time. If you're having trouble locating it, consult the owner's manual for specific guidance.
Hi There, I have a factory tape deck in mine and the clock on it is changed by holding down the "clock" button and pushing seek (right) for minutes and seek (left) for hours.
You have an broken wire in the clock spring.
theres a (probably white) button under the steering wheel, push up on the button while turning the key
turn on the radio and push in the valume button while holding that in use the seek or that other one to change the time
Push in the balance button(also volume) and push seek button it is labeled hours or minutes.
no
Huh?
It might fit but it will take you a while.
hold clock button and use the seek or other button underneath while holding the clock button
the secret is to have the radio off set button then just play with scan and seek
assuming this is the digital clock, you hit the clock button on the dash, followed by the reset button followed by the clock button. at this point, you should be able to hit the clock button to advance numbers, and the reset button to change the numbers you are setting. if its the analog clock, pull on the knob and turn it
The 1995 ford Aerostar did not come stock with a factory amp. If your van has an amp then it was added aftermarket.