answersLogoWhite

0

The cam position sensor is in the distributor. on both engines.

The crank postion sensor goes through the top left of the bell housing on the 4.0L and the top right on the V8.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where is the fuel pressure regulator located on a 1997 jeep grand Cherokee limited?

On the fuel pump module, in the tank.


How do you change the orfice tube on 1997 grand Cherokee limited?

How do you change the orifice tube on 1997 grand Cherokee jeep with 5.2 v/8


How do you change 1997 Jeep Grand Cherokee limited speakers?

You have to remove the door panels


Jack location for 97 jeep grand Cherokee?

The jack is located under the rear seat on my 1997 Jeep Grand Cherokee.


Where the relay is for the alarm on a 1997 grand Cherokee jeep and where the alrarm is located?

i need to disable jeep factory alarm 1997 cherokee


Where is the starter located on a 1997 Jeep Grand Cherokee Limited?

Six cylinder, on the lower passenger side of the engine. Eight cylinder, lower drivers side of the engine.


What would cause clunking noise in front wheels of a 1997 Jeep Grand Cherokee Limited?

Bad Struts


Why are the lights flashing on my 1993 Jeep Grand Cherokee limited?

I had the same problem with my 1997 Grand Cherokee and it was the dash mounted automatic light switch. The problem was also solved by turning the headlamps on manually.


Are 1997 Jeep Grand Cherokee radiators interchangeable with a 2000 Jeep Grand Cherokee?

no


What type of transmission fluid does a 1997 Jeep grand Cherokee limited V8 fwd take?

Mopar ATF+4


Where is the amplifier on a 1997 Jeep Grand Cherokee?

The amp is located under the rear driver side seat.


Where is the ABS control module located on a 1997 Grand Cherokee Limited?

Alot of the ABS controls I have seen were in the engine compartment on the Driver side near top. It will have brake lines coming from the master cylinder.