0
The Crank sensor is located right above the oil filter (on 2.4) to the left of the starter if looking from the front of the car. Pull the oil filter off. There is a small clip to pull harness out, remove that, then the 10mm bolt that holds that in. The bolt is kinda hard to see and get to, becareful not to strip it out. fairly simple, good luck.
What else can I help you with?
Where is the crankshaft sensor on a 97 Chevy cavalier z24?
Next to the oil filter, bolted to the block.
Where is the Crank sensor located on a 1997 Chevy Tahoe?
THE CRANK SENSOR ON A 97 5.7 IS LOCATED UNDER THE CRANKSHAFT PULLEY BETWEEN THE PULLEY AND THE OILPAN. SLIGHTLY TO DRIVERS SIDE
Distributor cap removal for 97 Chevy cavalier 2.2L?
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
How do you change your oil in a 97 Chevy Cavalier?
how to i put it at on the Chevy cavalier 2.2 l
Free engine diagrams for 97 Chevy cavalier?
how do i remove the upper intake manifold on a 97 chevy cavalier 2.2l v4
Wireing diagram for Chevy Cavalier?
"97 Chevy cavalier" radio diagram which wires go where
Where is crank sensor on 97 Chevy astro van 4.3?
The crank position sensor On your astro is located on front of the engine on timing cover, left side. Behind the crankshaft pulley. with a connector of 3 wires.
Where is the crank sencore on 97 Chevy vencer van 3400?
The 1997 Chevy crankshaft sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
How do you fix a clutch on a 1997 Chevy Cavalier Z24?
the clutch went out on my 97 Chevy cavalier how do i fix it
Where is the oxygen sensor on a 97 Chevy Cavalier?
The front o2 sensor is just to the left of the battery. It's a little tube with a wire that is plugged in right before the exhaust pipe.
Cost to repair crankshaft position sensor in 1997 Chevy lumina?
Just had this done on my 97, along w/ other work. It cost me around 325.00 for the crank sensor.
Is there a certain way to position the crank sensor on a K1500?
Is there a certain way to postition the crank sensor on a 97 k1500?
