0
==Answer 1 == Not having worked on your particular make and model, I can only give a generic answer, which GENERALLY APPLIES to most, if not all, automotive engines, and should help until an expert provides a more definitive answer. To the best of my knowledge, the only place where spinning motion of the crankshaft is observable and accessable is the CRANKSHAFT DAMPENER PULLEY which is mounted on the crankshaft at the "front" of the engine. On a transverse [crosswise] mounted engine, the front is considered the end that has the drive belt(s). Generally, the SENSOR size is usually no more than 1/2 to 3/4 inch in diameter, and 1 to 2 inches in length, and it will have one or two wires attached. The sensor will be mounted on a metal bracket attached to the front of the engine, and very close to the CRANKSHAFT DAMPENER PULLEY. The bracket locates the sensor IN THE "PLANE" of the pulley, in other words, "looking" at the EDGE of the spinning pulley. I hope this helps, until someone else contributes a more specific answer.
What else can I help you with?
Where is the crankshaft sensor located on a 1996 Pontiac grand am with 2.4 motor?
were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
Where is the camshaft sensor located on a 1999 pontiac Montana?
Cam sensor location 02 pontiac montana 3.4
What is the location of the crankshaft position sensor on a Pontiac Montana?
Oh, dude, the crankshaft position sensor on a Pontiac Montana is typically located near the crankshaft pulley or the flywheel. It's like the detective of the engine, always keeping tabs on the crankshaft's position to make sure everything's running smoothly. So, if your Montana is acting up, maybe give the sensor a little pat on the back... or a diagnostic check, whatever works.
Where is the crankshaft sensor located on a 1998 Pontiac Transport?
It is located behind the crankshaft pulley and requires the pulley to be removed to change it out.
Where is crankshaft sensor located and how do you change it on 1999 Pontiac Grand Prix?
there isn't a crankshaft position sensor on a 3.8l motor in a 1999 Pontiac grand prix according to the manual
Where is the crankshaft position sensor located on a 2001 Pontiac sunfire?
on the back of the motor wright below the crank sensor
Where is the location of the crankshaft sensor on a Pontiac Montana transport van?
That is closer to the time belt u have to remove the belt firts
Where is the crankshaft position sensor located on a 1996 Pontiac Bonneville?
The sensor is located on the right side of the the crankshaft attached by 2 bolts thru the timing cover it will be hard to see due to the pulley.
Where is the oil pressure sensor located on 1999 Pontiac Montana?
You can find the oil pressure sensor for your 1999 Pontiac Montana on the front of the engine. The low pressure oil sensor will be just below the left cylinder head.
Where is the crankshaft sensor on a 1995 Pontiac grand am 3.1?
The 1995 Pontiac Grand Am 3.1 liter engine crank shaft sensor is located inside of the rear engine cover. You will need to remove the rear engine cover in order to access the crankshaft sensor.
When replacing the crankshaft position sensor on a 2001 Pontiac Montana 3.4 is there a need to take it to a dealer for a Learning period?
All you need to do is erase the trouble code associated with the crankshaft positioning sensor. You will need a code reader to do this.
Where is the oxygen sensor located on the 1999 Pontiac Montana Minivan?
The oxygen sensor is located in the exhaust manifold near the firewall. It is easier to get to the sensor from under the vehicle.
