In a 2008 Ford F-250, the Differential Pressure Feedback EGR (DPFE) sensor is typically located near the EGR valve, which is situated on the intake manifold. It is usually mounted on or near the firewall, on the driver's side of the engine compartment. The sensor has two hoses connected to it that measure the pressure difference across the EGR system. To access it, you may need to remove some components for better visibility.
Where is cylinder temp sensor on 2000 Ford f250 with v10 engine
On the exhaust pipe between the engine and the catalytic converter
what engine? most will be close to the t-stat.
On my 1989 f250 the oxygen sensor is in the exhaust header pipe a few inches in front of the catalytic convertor
look at your trany it should have a wire going into it on the top side in the middle
on the timing cover sensing the damper
The oil pressure sensor on an f250 engine is located at the back toward the firewall. It is centered side to side close to the intake.
What position is the crank sensor on a f250 ford pickup
On the fuel pump
camshaft sensor for 2001 f250 is located on front of block above the bottom pulley wheel this is accessed easiest from underneath the vehicle
where is a cam sensor on a 2006 ford f250 6.0L diesel engine?
The RSC sensor is located on the steering collum, Under the dash by the Optic Wheel.