The serial # and the date that the engine was made is on the side of the engine block by the freeze plugs on the passenger side of the engine., if you looking for the engine size it's stamped into the engine block behind the distriburetor on the block and if a 440 it's on a plate just above the waterpump.
basic 67 charger was about $3,200.
Depends on the engine, transmission, gearing, condition of car, etc...
if your 67 had a 318 engine in it from the factory the 360 should bolt right in.
that all depends on what engine is in both vehicles.
about 3,600 lbs.
1967
5x5
That all depends on the engine and rear end in each vehicle.
take it off
1967, 1968, 1969, 1970.
you could get any size engine in it that dodge offered from the 225 six up to the 426 hemi.
The fuse panel for a 1967 is under the left vent control up inside the dash. Located on the drivers side of the vehicle.