on the bottom of the sump, i think it is a 19mm hex bolt, it does not look like a sump plug it looks like a mounting bolt for the engine but if you can get the car high enough and get good light in you will see it o.k.
Underneath the engine on the sump ( or in USA terms the oil pan)
Hi the engine oil drain plug is under the engine on the engine sump.Place a bowl under the sump remove oil plug look out for the washer it fulls off and goes in the bowl which is now got engine oil in it. Hope this helps
The engine oil drain plug is on the bottom rear of the engine oil pan. The transmission does not have a drain plug, you remove the pan to drain.The engine oil drain plug is on the bottom rear of the engine oil pan. The transmission does not have a drain plug, you remove the pan to drain.
You drain the engine oil from the drain plug on the bottom of the oil pan.You drain the engine oil from the drain plug on the bottom of the oil pan.
The engine drain plug is located under in the side of the oil pan faces the rear drive shaft
The engine oil drain plug is on the bottom of the engine oil pan.
The oil drain plug on a Rover 75 V6 is located on the oil pan at the bottom of the engine. To access it, you typically need to raise the vehicle and position yourself underneath. The plug is usually a hex or square bolt that can be removed with a suitable wrench. Always ensure to have a container ready to catch the oil when you remove it.
Where is oil drain plug on 2007 avalanche
To change the automatic gearbox oil on a Rover 75, first ensure the vehicle is on a level surface and the engine is warm. Remove the oil pan or drain plug to let the old oil drain out completely. Replace the drain plug, then refill the gearbox with the appropriate new oil through the dipstick tube or fill plug, using a funnel. Be sure to check the oil level with the engine running and adjust as necessary, ensuring it is within the recommended range.
The engine oil drain plug would be found at the lowest point of the engine oil pan.
On the bottom of the engine block. It has a drain plug in it for draining the oil.On the bottom of the engine block. It has a drain plug in it for draining the oil.
With the engine off and the plug wire off the spark plug, you will need to remove the drain plug on the bottom of the engine. Drain the oil, install the plug and fill with 30w oil.