0
On the 1987 Oldsmobile Cutlass Ciera with a 3.8L engine, the fan relay is typically located in the engine compartment, mounted on the passenger side near the radiator. It is often found within a relay center or as a standalone component. You may need to consult the vehicle's service manual for the exact location and wiring details.
What else can I help you with?
Where is the signal flasher located on a 1987 Oldsmobile Cutlass Ciera?
Where is the signal flasher located on a 1987 Oldsmobile Cutlass Ciera?
1987 Oldsmobile cutlass ciera oxygen sensor location?
what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6
What is the recommended engine oil for a 1987 Oldsmobile Cutlass Ciera?
5w30
How do you remove the spark plugs on a 1987 Oldsmobile Cutlass Ciera?
with a spark plug sockett
How to fix 1987 olds cutlass ciera radiator fan will not stop running?
Thermal relay is stuck. Replace it.
What should the oil pressure be in 1987 Oldsmobile cutlass ciera?
General rule is that you need 10psi for every 1,000 rpm's of the engine.
What is the horsepower of a 1987 Oldsmobile Cutlass Supreme?
The 1987 Oldsmobile Cutlass Supreme was rated 350 horsepower with the with the V8 engine. It was last year that the Cutlass was a rear wheel drive vehicle.
Is a 1987 cutlass ciera a rerwheeldrive car?
I have 2 of these cieras and NO they are front wheel drive, the cutlass supreme is real wheel drive
What is the rim lug pattern on a 1987 Oldsmobile cutlass supreme?
5 by 4.75
Wiring diagram for a 1987 Oldsmobile cutlass sierra?
Engine rotates but will not start
What is the cooling system fluid capacity for an 1987 Oldsmobile cutlass cierra?
The 1987 Oldsmobile Cutlass cooling system has a fluid capacity of 5.5 gallons. The cooling system fluid should consist of 50 percent antifreeze.
Where's the relay for the electrical antenna of a 1987 Cutlass Ciera and how do you get the antenna to work?
The relay is located on the bottom area of the antenna itself. Most of the time the motors burn out, or the gear inside the motor strips out. If that's the case, replacing the whole assembly is the easiest fix.
