0
What else can I help you with?
What type of refrigerant on a 2000 Oldsmobile Bravada?
r134a
Where is the fuel pressure sensor located on a 2000 bravada?
I have a 1997 and it is located on the fuel pump. It plugs into the top of it.
What type of oil do you use in a 2000 Oldsmobile bravada?
5w30
What makes the crankshaft position sensor go bad?
what can make a crank shaft sensor keep goin bad even if its been replaced 4 times.. in a 2000 oldsmobile bravada
Where is the knock sensor located on the 2000 Oldsmobile bravada?
On the 2000 Oldsmobile Bravada, the knock sensor is located on the engine block, typically on the driver's side, beneath the intake manifold. It is positioned near the cylinder head, often requiring removal of some components for access. Make sure to consult the vehicle’s service manual for precise details and any specific procedures for replacement.
What kind of cars do you have?
1999 GMC Jimmy Envoy 2001 Chevy Impala 2001 Ford Escape 2003 Mercury Grand Marquis 2002 Oldsmobile Bravada 1996 Oldsmobile Bravada 2000 Chevy Venture 1994 Kawasaki Vulcan 1500
Where is the transfer case on a 2000 Oldsmobile Bravada?
It is under the car behind the tranny
What is the capacity of the fuel tank in a 2000 Oldsmobile Bravada?
I believe it's 18 gallons.
What kind of frame Does the 2000 Oldsmobile Bravada have?
It is a body on frame design. https://www.gmpartsdirect.com/auto-parts/2000/oldsmobile/bravada/base-trim/4-3l-v6-gas-engine/body-cat/frame-and-components-scat
Where is the speed sensor on a 2000 Olds Bravada Smartrak and how hard is it to change?
The speed sensor on a 2000 Olds Bravada Smartrak is on the top of the automatic transfer case. To change it you need to disconnect the two wires and replace with a new sensor.
What transmission fluid do you use on Oldsmobile 2000 Bravada?
The 2000 Olds Bravada uses Dextron iv automatic transmission fluid. The fluid is specific and other types should not be substituted.
How do you replace the fuel regulator on a 2000 Oldsmobile bravada 4.3 liter engine?
it is located inside the intake manifold
